bestballer717 bestballer717

21-03-2024
Mathematics

contestada

The specifications for the diameter of a molded part are 10 mm ± 0.5 mm. The actual average and standard deviation from 250 parts sampled is 10.1 mm and 0.1 mm, respectively. What is the process cap?
a) 0.2
b) 0.5
c) 0.05
d) 0.1

Respuesta :

Otras preguntas

Article II of the Constitution states that the president is alsoleader of the Senate.a general in the armymander in chief.leader of Congress.

In browsing through the chimpanzee genome, you find that it has three homologs of a particular gene, whereas humans have only two. a. What are two alternative e

Dado el polinomio: P(x) = xa+3 + xa+4 + x+2 + 2a Calcular el término independiente si GA = 8.

the multiplier (expenditure multiplier) is the ratio between which two measures?a. the u.s. government increases the minimum wage.

The systems that work together to acquire and use energy are Group of answer choices skeletal and muscular. nervous and endocrine. digestive, respiratory, and c

basic purpose of which of the following acts was to curtail and limit union practices? a. the wagner act b. the sherman antitrust act c. the rowlatt act d. the

explain how electrical devices can begin operating almost immediately after you throw a switch, even though individual electrons in the wire may take hours to r

Ida is a 45-year-old woman who comes into the emergency department complaining of painful swelling, drainage and redness in her arm over the past 5 days. She sp

A compound is found to contain 9.227 % boron and 90.77 % chlorine by mass. What is the empirical formula for this compound?

By combining elements from the first wave of popular fusion groups from the early 1970s along with popular rock groups that showcased their powerful horn sectio